DENSO (KUBOTA/SUBARU/DAIHATSU) BOARD + SOCKETS FOR SOLDERED CONN.0,5 MM F34NTA21

The object of sale is the FLEX FLK02.V02 device containing additional connectors and a cable with ECU OBD Bench protocols in Slave mode. The successor of the X17 device, it enables reading the contents of the controllers’ memory both via the OBD connector, in Bench and Boot mode. The primary function of the device is reading and writing flash and eeprom memory, as well as full cloning of engine and gearbox controllers. Ultimately, all protocols currently supported by the X17 module will be ported.

The kit includes the following connectors:

FLX4.2G: connectors for EMS3140, EMS3141, EMS3160, EMS3161, EMS3142
FLX4.2H: connectors for EDC17C49, EDC17C69, EDC7UC32, EDC7C1, EDC7C2, EDC7C3
FLX4.2I: connectors for MDG1
FLX4.2L: connectors for earthmoving machinery, trucks, agricultural machinery and construction vehicles, including Cummins CM2150C, Cummins CM2150E

The kit also includes the FLX2.14 cable: manufactured by Magicmotorsport, it allows the Flexbox to connect directly to the vehicle’s standard OBD port. This 44-pin connector accessory allows you to use the Flexbox touch button to select one of four available modes during bench programming and more.

The subject of sale is the FLEX device with protocols OBD (car, vans, bikes) Bench in Slave mode. The successor of the X17 device allows reading the contents of the controller’s memory both through the OBD connector, in the Bench and Boot modes. The basic function of the device is to read and write flash and eeprom memory, as well as full cloning of engine and transmission controllers. Ultimately, all protocols currently supported by the X17 module will be transferred.