KESS3 DL382 DSG TCU VAG Bench Cable

KESS3 DL382 DSG TCU VAG Bench Cable

KESS3 DL382 DSG TCU VAG Bench Cable is a specialist cable designed for DL382 DSG TCU automatic transmission control units used in Volkswagen / Audi Group vehicles.

The cable enables direct connection between the KESS3 programmer and the TCU in Bench mode, outside the vehicle. This solution allows convenient reading and writing of transmission control unit data without working through the vehicle OBD socket.

Using a dedicated Bench cable helps reduce the risk of incorrect pin connection, lowers the risk of ECU/TCU connector damage and speeds up everyday work with DSG transmission controllers. It is a practical accessory for workshops dealing with transmission tuning, TCU programming, diagnostics and automotive electronics.

Application

The cable is intended for DL382 DSG TCU transmission control units used in VAG vehicles, especially Volkswagen and Audi. It enables Bench mode operation for TCU reading and writing with the KESS3 programmer.

Before purchasing, we recommend confirming compatibility with the exact TCU version, vehicle model and active protocol available in your KESS3 device.

Key features

• Bench cable for KESS3 programmer,
• designed for DL382 DSG TCU controllers,
• application: VAG / VW / Audi vehicles,
• enables direct connection to the TCU on the bench,
• designed for transmission control unit reading and writing,
• helps reduce the risk of incorrect pin connection,
• reduces the risk of controller connector damage,
• speeds up TCU programming and diagnostic work,
• cable length: approx. 1.5 m,
• intended for professional workshop use.